3. Sit and Reach Test

Measure the sit and reach distance and upload to IoT platform.

../../_images/sitandreach.png

Building Instructions

Building Instructions

../../_images/pushup_wire.png

Sample Program

Sensor

../../_images/sitandreach_code1.png

Sample Program

Controller

../../_images/sitandreach_code2.png

Sample Program

使用方法

  1. Place the sensor on a table facing a wall.

  2. Turn on the Robotbit and wait for Wifibrick to connect to MakerCloud.

  3. Sit right and hold out the hands, push the device against the tip of the hand, press A on the controller to set a baseline.

  4. Push the sensor towards the wall, press B on the controller to measure the distance.

  5. The sensor will show and upload the sit and reach distance onto MakerCloud.